Start with your 2D sketch looking down from the top:
(no need to add dimensions to your sketch, they are included here just for your reference)
It will be easier to extrude if you make everything into rectangles, rather than individual lines.
Extrude the base down 1.75 (that way you are not covering up the lines on the top)
Extrude the back up 7.00
Use the wedge shape for your slanted surfaces:
Pay attention to the order of where you click!
Height = 1.25 ↓
Keep using those wedge commands! You should be able to snap your endpoints to the lines you drew previously.
side wedge Height = 3.25 ↓
Extrude
Center block Height = 4 ↓
Center Wedge Height = 4 ↓
Side wedge Extrude Height = 3.25 ↓
Join all of your solids together with "Union"
Use VIEWBASE and place it on your titleblock on 8.5 by 11 layout!
Try out a few other ws's, and keep working on that project!
